This is usually under a DHCP Leases type page within the admin interface. Telnet is an insecure protocol for remote server configuration.
#SWITCH TO ROUTER CONFIGURATION HOW TO#
Shutdown R1’s FastEthernet0/0 interface then configure PortFast on SW1’s FastEthernet0/1. Check UniFi Managed Switch is Showing in Firewall/Router Ok, so now you’re plugged in, you need to head over to your Firewall/Router Admin screen and view the devices on the network. How to configure Cisco Router/Switch to enable SSH (Secure Shell) and How to connect Cisco Router/Switch using SSH (Secure Shell) Telnet was the protocol which Network Administrators were using for accessing the CLI console of a server or a network device remotely. Enable FastEthernet0/0 which is connected to Fa0/1 then observe the switches spanning-tree behavior via the show spanning-tree command. I've seen servers named after fighter planes (hornet, falcon, etc) named after LoTR character names, etc. By default, interfaces on routers are administratively shut down. another game often played is to name all your devices following a family/category of name. Instead of saying that the Core Switch has blown, you can say "insert-device-name-here died".
#SWITCH TO ROUTER CONFIGURATION WINDOWS#
This is nothing much more than if you entered a computer name in your PC's windows setup.Ī side effect of that is that it's wayyy more fun to refer to your router/switch name than it's IP and/or function The device will now refer to itself by " name-of-device" instead of a generic name (ie: router, switch, etc) in prompts, syslogs, CDP/LLDP, etc.
Configure the switch as the DHCP server to assign IP addresses to users. You can make the switch easier to locate in the. Configure the switch as the gateway of users to allow users to communicate across network segments through VLANIF interfaces. Enter Privileged EXEC Mode and Set a Hostname for the Switch. To start configuration, you want to connect the switch console to PuTTY. However, the solution can be achieved in many different ways. How to Configure Cisco Switch: A Step-by-Step Guide with Commands 1. The commands used here a for the lab represented in the network topology used here. But as the name is often used to (depending on manufacturer/line) The following configuration commands will the required to configure a Cisco switch for remote management. There are no technical requirement to "name" a device. I'll take it that you're talking about giving the device a hostname
0 kommentar(er)
